The motor is used to automatically adjust the temperature of the greenhouse film can not pull more than 10 meters,  reminder! ! !

A. Series of main parameters

Model: 120FH-1

Power: 20W
Voltage: AC220V
Rated speed: 1r / min = 1 rpm
Output torque: 100kg.cm = 10N.M
Weight: 0.9kg

Second Dimension (mm):




III. Presentation Description

1. Synchronous Motor direction can be changed by changing the wiring, features: This product is made of permanent magnet synchronous motor and a reduction mechanism to control the synthesis of one of the pros and cons of gear synchronous motor. With low power consumption, large torque, low noise, small size, light weight, easy to use features.

2. supporting the use of couplings, gears, sprockets, timing pulley, bearings, optical axis, reversing switch, remote control switch

3. Mainly used: Greenhouse auto motor temperature, monitor head, electric equipment, heating and cooling through the valves, automated instrumentation, electric models, electric advertising, mahjong, screen machines, presses, cash registers, barbecue equipment electric apparatus and summons all small constant speed operation, low power devices

The following table for the Division I all synchronous motor models and parameters:

if you need the other part number motor as the list shows please contact us

 

Motor Caution:

1. Before using make sure the motor voltage is correct, even if the DC motor to confirm the adequacy of the supply current.

2. Use not overload, overload reasons mainly of two parts, torque and axial force, the load torque of the motor can not exceed the rated torque discontinuity axial and radial shaft may exceed the allowable stress axis, plus after the load should not exceed the rated current of the motor measured current, general motors must be accompanied by burning fuse to avoid overloading the motor.

3. Do not store or operate in hot or humid environments, but also do not place in corrosive gas, the effect will reduce motor

4. The motor shaft assembly transmission parts such as gears, pulleys when, in press-fitting Do not knock the exception.

5. Power on the positive and negative terminals of the motor when you want to solder, soldering iron temperature of 340  ± 40 , heating time within 3 seconds, not the plastic deformation, at work, so that the solder flows into the motor point or broken wire ends, it will motor function decline.

6. When the installation of the motor, note the screw is too long, too long to prevent the screw press touch electrical parts inside.

7. Torque concept: for example, drive pulley, 10KG.CM torque, belt pulley radius 1CM there 10KG tension pulley radius 5CM if only 2KG belt tension.

8. Common units: 1N.M = 10KG.CM == 0.1KG.M, 1HP = 750W, 1W = 1V.A