| Phase: | Single-phase |
|---|---|
| Type: | Asynchronous Motor |
| Efficiency: | IE 1 |
| Certification: | CE |
| Model Number: | 220V 6W 90 rev / min |
| Protect Feature: | Totally Enclosed |
| AC Voltage: | 220 |
| is_customized: | Yes |
| Unit Type: | piece |
| Package Size: | 15cm x 15cm x 15cm (5.91in x 5.91in x 5.91in) |
| Package Weight: | 1.4kg (3.09lb.) |
Quick Details
Specifications
I. Technical parameters
Rated Power: 6W rated speed: 90r / min
Rated voltage: AC220V Output Torque: 7.2kg.cm
Rated current: 0.13A gearbox reduction ratio: 1: 15 Weight: 1.2kg
II. Dimensions
III. Product Description
1. The speed motors with different reduction ratio gearbox, with another series of power as well as the table of specifications for selection:
if you need the other part number motor as the list shows please contact us
2. The motor is AC 220V power supply, otherwise there is a motor 380V power supply, the need to increase 25 yuan, need please contact us
3. brake motors have immediate requirement or the output shaft to be equipped with a self-locking capability brake mechanism, I shop there Brake supply needs, please contact us
Motor Caution:
1. Before using make sure the motor voltage is correct, even if the DC motor to confirm the adequacy of the supply current.
2. Use not overload, overload reasons mainly of two parts, torque and axial force, the load torque of the motor can not exceed the rated torque discontinuity axial and radial shaft may exceed the allowable stress axis, plus after the load should not exceed the rated current of the motor measured current, general motors must be accompanied by burning fuse to avoid overloading the motor.
3. Do not store or operate in hot or humid environments, but also do not place in corrosive gas, the effect will reduce motor
4. The motor shaft assembly transmission parts such as gears, pulleys when, in press-fitting Do not knock the exception.
5. Power on the positive and negative terminals of the motor when you want to solder, soldering iron temperature of 340 ± 40 , heating time within 3 seconds, not the plastic deformation, at work, so that the solder flows into the motor point or broken wire ends, it will motor function decline.
6. When the installation of the motor, note the screw is too long, too long to prevent the screw press touch electrical parts inside.
7. Torque concept: for example, drive pulley, 10KG.CM torque, belt pulley radius 1CM there 10KG tension pulley radius 5CM if only 2KG belt tension.
8. Common units: 1N.M = 10KG.CM == 0.1KG.M, 1HP = 750W, 1W = 1V.A