1. Safety Instructions

PLEASE READ THESE INSTRUCTIONS CAREFULLY PRIOR TO INSTALLATION OR OPERATION OF THIS PRODUCT.

1.1 Please make sure the output voltage of wind generator is consistent with rated battery voltage.

1.2 Please connect the cables of plus-n-minus of battery firstly and then connect the three cables of wind generator.

1.3 Please make sure you connect battery and wind generator with controller according to this instruction, opposite polarity or wrong position connection will result in abnormal operation of system or damage of system components.

1.4 When operating hand braking, please make the smaller red cable and battery anode in short circuit, then controller will brake. Disconnect the smaller red cable, hand braking function will be cancel.

 

2. Wiring

2.1 Connect the “+” and “-“of battery with battery plus-n-minus input terminals of controller.

2.2 Connect the three cables of wind generator with three voltage input terminals of wind generator of controller.

 

Features:

Rate Battery voltage:48V

Brake voltage: 60V

Recovery charging voltage: 54V

Be able to 100w to 600w wind-turbine, 48V

Mini size, be easy to be install

 

Specification:

 

Items	FW10-48-A
Rated Battery Voltage	48v
Rated Wind Generator Capacity:(Min)	1000W
Rated Wind Generator Capacity:(Max)	1000W
Wind Generator Braking Voltage	60V
Wind Generator Recover Voltage	54V
Wind Generator Braking Current	25A
Display Mode	LED
Ambient Temperature	-35~+75℃
Dimensions(L x W x H)	150mm×132mm×48mm
Quiescent Current	≤20 mA
IP Protection Level	IP67

Installation:

AC in: connect the wind turbine to three green cables

DC out: connect the black cable to the negative pole of battery; connect
the red cable to the positive pole of battery.

 

Package: