Description:

Material: Plastic

Color: See Pictures

System Voltage:12V

Output Current: 3A

Working Temperature: -20°C~55°C

Protection Degree: IP30

Charge Loop Drop: ≤0.7V

Disharge Loop Drop: ≤0.1V

Features:

This Solar Charger Controller can automatically manage the work of Solar Panel and battery in solar system

It\\\'s widely used for the solar light on street, garden, park, etc

Solar charger controller can control the battery recharging automatically and make sure the batteries work longer and safer

Just working for lead-acid battery‘s charging control

Equipped with the MCU, artificially controlled

Equipped with device to avoid the overcharge, over release, electronic short circuit, over loading, battery inversely connecting, solar battery inversely connecting

The series connection PWM circuit is implemented to form the major charging circuit, make the voltage loss 50% lower than the diode charging circuit, and the charging efficiency 3%-6% higher than the non-PWM

The LED displayer shows the batteries current situation to make the customer get the information of the batteries

The controller can automatically identify the voltage of 12V

Tips:

The preparation of the conducting wire:calculate the length of the wire ,and then figure out the installation place,make sure the length of the wire is reasonable to decrease the loss of the electricity

Connect the battery first,pay attention to the anode and the cathode to avoid the inverse connection.the indicator light of the battery willwork if the connection is correct,otherwise,it will not ,but the component of the controller will not be damaged

Connect the wire of the solar panel, pay attention to the anode and the cathode to avoid the inverse connection

If the connection is correct,the indicator light of “CHARGE”will be on or flash 10 seconds later after laying outside under the sun,otherwise,please check the connection

Make sure the solar energy panel is laid outdoors under the sunshine

Connect the load at the end,pay attention to the anode and the cathode to avoid the inverse connection .if inverse connection ,the led lamp may be damaged

The batteries has stored much energy,please keep the batteries from the short circuit under any circumstances,we strongly recommend connecting the batteries with the fuse

Please avoid the short circuit wire and the terminal,for the wire and the terminal may generate voltage two times higher than the rated voltage of the controller

Please use the insulated tools while operating the controller

Ensure the children keep away from the battery and the controller

Note: 

Due to the difference between different monitors, the picture may not reflect  the actual color of the item. Thank you!

Package include:

1 Pc x Solar Panel Charger Controller Regulator Park Street Garden Light Plastic 3A 12V

\'