50pcs string 12mm WS2811 digital led pixel module IP68 waterproof DC5V input full color addressable pixel module

 

Controller link:

http://www.aliexpress.com/store/product/free-shipping-digital-programmable-led-pixel-controller-support-IC-WS2811-LPD6803-WS2801-TM1804-etc-T-1000S/820257_1207383564.html

 

Specification:

RGB LED pixel lighting (WS 2811 IC), similar function as pixel module with WS2801 IC. Just WS2811 with three wires.

Working voltage: DC5V

Working current: 20mA, max.60mA                        

Working consumption: max.0.3W
Working temperature: 40°C- 60°C

IP grade: IP68

Dimension: 12mm

LED type: 1pcs strawhat

LED qty: 1pcs           

 

 

Wiring as below:

 

RED: DC5V+ (the side with IC WS2811)

WHITE: DATA

BLUE: GND

  

 

RGB Pixels are digitally-controllable lights you can set to any color, or animate Each RGB LED and controller chip is molded into a 'dot' of silicone.

 

The dots are waterproof and rugged. There are four flanges molded in so that you can 'push' them into a 12mm drill hole in any material up to 1.5mm/0.06" thick. They are typically used to make outdoor signs. Compared to our other 20mm LED dots.

 

These are diffused 8mm LEDs so they are not as bright but they color mix a little nicer. The pixels are connected by a 3-conductor cable. Red is +5V, Yellow is Ground, Green is Data and Data is shifted down from one pixel to the next so that you can easily cut the strand or attach more onto the end. Each dot is digitally controlled, with an internal 5-bit PWM LED driver (15-bit color for 32,768 different shades). The pixels must be clocked by a microcontroller. The pixels use 8mm diffused RGB LEDs with brightness of about 300 mcd per individual r/g/b LED.

 

The pixels use 8mm diffused RGB LEDs, with a 120 degree beam width. The total max brightness of all LEDs is about 1600mcd but with the light more evenly distributed & mixed than a clear LED