Product Description

Specification:

Voltage: AC12V

Power:

           

F5 LED (0.06W/LED) - 316LED 19W /456LED 27W/546LED 32W

120 degree beam angle ,high in emitting area ,soft light

                

Material: 304 Stainless steel/Glass

Changing Mode: Remote Control, On/off Control

Lifespan: 50,000 Hours

IP Grade: IP68

Color: 1. For RGB: Remote Controller, Automatic Color Changing (Can be drived by 12VAC only ,the lamp RGB without remoter is color changing automatically ,the lamp with remoter can be controlled by remoter)

          2. For Single Colors: Red, Yellow, Blue, Green, White, Warm White(can be drived by 12Vac or 12VDC)

 

 

Mainly Features:
1. Easy to install. 
2. 7 kinds of color changing. super brightness. 
3. Low power consumption.
4. Safe to use ( work with 12V voltage). 
5. Widely use in swimming pool, fountain and spa

Use the lamp switch to control the lamp mode.

LED underwater lights have been pre-programmed LED mode, the operation is as follows:

 

1. When the power is turned on, all lights can be in the same mode.

 

2. In order for all LEDs to be in the same mode, you have to do this by clicking on the method:

 

A. Make sure that all lights are connected to the same power switch.

B. Disconnect and close the power supply continuously for 5 seconds.

C. When you turn off and turn off the power for the third time, all lights are in the same mode (the green light is on, that is, mode 8.) Now if you want to jump to the mode you want, Close the power can be, each time off and closed time shall not exceed 5 seconds. It is recommended that the time for opening and closing is about 1 second.

D. Disconnect the power for more than 20 seconds, and when you turn the power off again, all lights are in the previous mode. The

Iv mode description

Mode 1: red, green and blue lights all bright

2. Mode 2: The red light is on

3. Mode 3: The green light is on

4. Mode 4: Blue light is on

5. Mode 5: blue light is always bright, red light gradient

6. Mode 6: green light, red light gradient

7. Mode 7: blue light is always on, green light gradient

8. Mode 8: Blue green light is on

9. Mode 9: red green light is on

10. Mode 10 blue red light is always on

11. Mode 11: blue light is always on, traffic light gradient

12. Mode 12: green light, red and blue light gradient

13. Mode 13: red light is always bright, green and blue light gradient

14. Mode 14: Multiple flashing.

Multiple flickers consist of three parts. The first part: LED lights from fast to slow forward, about 30S. The second part: LED lights from fast to slow reverse, the time is about 30S. The third part: the red and blue light fast flash three times, and finally the red and blue lights together quickly flash three times, about 3S.

15. Mode 15: Multiple Gradients.

In this mode, the LED will follow the order of gradient:

(1) red gradient (including fade and fade) à (2) blue light gradient à (3) green light gradient à (4) red and blue gradient à (5) green blue gradient à (6) red and green gradient à (7 ) Blue light gradient à (8) Red and blue gradient à (9) Green light gradient à (10) Green blue light gradient.

This change will continue.

16. Mode 16: consists of pattern 14 and pattern 15.

 

LED underwater lights special features LED underwater lights have two special features:

Constant current drive and the entire LED lamp filling.

 

1, before the power, to ensure that all the alignment is correct, to ensure that the wire without cracks, gaps and so on.