Please leave us massage for you need "315MHZ" or " 433.92MHZ"

Here is only Receiver for   Professional,     

                                   without the transmitter 

 Here is only Receiver without the Transmitter

First of all, you must make sure your own transmitter frequency is 315MHZ or 433.92MHZ 

what is the IC Chip Number 

our receiver is learning code, it can learn most of Fixed Code and Learning Code Transmitter,

IC Chip like this (2262 2264 2260 2240 1527 etc)

it can not work with rolling code transmitter 

DC12V 1CH Receiver Board

1.Working Voltage: DC12V more or less than 10%
2.Current:Standby≤10mA,Working ≤128mA
3.Working Temperature: -10'C—+60'C
4.Receiver Frequency: 315MHz/433MHZ
5.Receiving Sensitivity: -105dB
6.Output State: Switching Value
7.Max Load:10A Relay, Resistive load≤8A,Inductive load≤3A
8.Receiver Board Size:55×31×16mm
9.Case Size:73×36×24mm

Learning Code: Add transmitter by the Learning Button on the receiver

Output State:     It is adjusted by the Jumper on the Receiver Board, (before you change it .you need turn OFF the power. Until you have changed it, then turn ON the power again, or the State will not be changed)

Momentary----------Jumper on “1&2”

Toggle----------------Jumper “2&3”

Latched--------------Take away the Jumper or put the Jumper on 1 Pin

Momentary------------Press the Transmitter button and keep, the receiver relay is ON, release button, the receiver relay is OFF,

Toggle---------------Press transmitter button for 1 time, the receiver relay is ON, press button again, the receiver relay is OFF,

Latched------------------Press transmitter button A, the receiver relay A is ON, Press Button B, the Receiver is OFF

Learning Method:
Input power for the Receiver .Press the Learning Button until the Led indicator ON. Then press transmitter, the Led indicator flash fast, it mean learning successfully.

Clearing Code
Keeping press the Learning Button on the receiver until the LED indicator ON and flash fast, it mean the code have been cleared successfully.