• Color: as shown in pic
• Description:
• Not provide technical support. you should know how to use it. If not, think twice before your order. Thanks!
   
• LED high-pressure board conversion instructions
• 1: Connect the power, ground, and switch signals required by the booster board to the universal LED booster board
• VCC Power ON Switch Signal ADJ Brightness Control GND Ground
• HINT: Connect the same way as the LCD high voltage board
• 2: with a multimeter to measure the amount of LED light bar is the number of lines, which are a few negative which are the number of lines which are a few lines
• Line is only in the more positive and negative points, engage in technology should not amount to see the original boost board can see out of the definition.
• [Product Name]Super universal interface 2P 6P 10P 12P full interface universal LED boost board LED high voltage board
• LED connection must pay attention to the definition of the interface is only positive and negative points, the positive input power supply must not be reversed or wrong,
• Improper connection caused by the consequences of their own, special reminder, but also understanding.
• [Size] 12.3cm * 3.1cm
• [Annex] send six LED cable + 1 power supply control line 6P 10p 12P soft row 6P electronic lines
• [Interface definition] Outputs 12 interfaces
• -3 + 4-3
• -4 + 2-4
• + 3-9
• -1 + 1
• -2 + 2-2 electronic wire
• -2 + 2-2FFC
• -4 + 2-4
• -3 + 4-3
• -5 + 2-5 * 2
• Small mouth * 2
   
• Input: Power supply switch signal brightness control ground wire
• (Same as LCD)
• Not all of the interfaces are soldered on, we pre-installed one or more details see above description.
• Quantity: 1PC
• Note:
• Due to the difference between different monitors, the picture may not reflect  the actual color of the item. Thank you!

Package including:

1 x Board