Decoder using the method

The first DMX address setting:

The decoder set the address bit by coding switch, of which 1-9 is for setting the start address of the Binary numeric code switch of DMX512, the first one is the lowest position, the ninth one is the highest
Bit of address code can be set to 512.

DMX512 start address code is the sum of switches 1-9, at the same time turn downside of the code switch (ON set to "1"), then the value of the bit can be gotten; coding switch up (set to "0"), the value of the bit is 0.

Decoder to use:

Note: FUN = OFF (the tenth code switch up) means to accept DMX512 signal mode
The first DMX address setting:
The decoder set the address bit by coding switch, of which 1-9 is for setting the start address of the Binary numeric code switch of DMX512, the first one is the lowest position, the ninth one is the highest
Bit of address code can be set to 512.

DMX512 start address code is the sum of switches 1-9, at the same time turn downside of the code switch (ON set to "1"), then the value of the bit can be gotten; coding switch up (set to "0"), the value of the bit is 0.
 

Example 1:

As the following Schematic 1, DMX512 start address is set to 38,

encoding the No. 6,3,2 position on switch dial to "1", others set to "0",

then the sum of the switch 1-9 code value is 32 + 4 + 2,

that is the DMX512 start address 38        

Example2:

As the schematic 2, DMX512 start address is set to 388,

encoding the no. 2,3,6,8 switch dial to "1", others set to "0",

then the sum of the switch 1-8 code value is 4 + 128 + 256 = 388,

that is the DMX512 start address 388.                                           

Operation instruction for the automat effect

Note: It will be Automatic operation mode when the No. 10 switch is turned down.

Effect choice (button switch No.1 to No.4):

1. Push No.1: Automat cycling.                                       2.Push No. 2: Seven-color gradual cycle changing.

3. Push No.1 &2: RGB Fade in and out                               4. Push No.3: Severn color jumping

5. Push No.1 & 3: RGB  jumping.                                     6. Push No.2 & 3: Static red

7. Push No. 1 & 2 & 3:Static green                               8. Push No.4: Static blue

9. Push No.1 & 4: Static yellow                            10. Push No.2 & 4: Static purple

11. Push No.1 & 2 & 4: Static cyan                          12. Push No.3 & 4: Static white

Speed Choices (Button Switch No.5 to No. 8)

1.     Push No.5: 0.5 second. 2. Push No.6: 1 second. 3. Push No.7: 1.5 second. 4. Push No.8: 2 second.

Schematic for System Connection:

Installation Notes:

This kind of controller works only under DC12V-24V, which is provided by the matched controllable main power, or else the controller will be damaged.

The UTP wire is connected hand in hand to make the cable, when two or more controller connected.

The power supply should be off when connecting the electric wires, and it can be turned on till making sure the wires are connected correctly and the indicator of main power in red is lighting.

Controller should work under the environment of adequately ventilated, dry, not corroded, no flammable gas and rust.

Please check the wires connection regularly so that the wires of aged, rust-eaten, and damaged insulation spacer can be replaced timely