1. Master On(–)/Off(O)

Acts as a master On(-)/Off(O) control for  all paired RGB(W) lights. Also activates

the “Master”function, which allows the remote to control the RGB(W) lights of

all zones. If a zone  is currentlyactive, pressing the master  On(-) button restores

the “Master” function to the remote.

2. Selection LED Indicator

Flashes once to indicate when a command has been selected.

3. Brightness Touch Slider - Increase(Right Side)/Decrease(Left Side)

Increases(right  side) or decreases(left  side)  the brightness  level. Changing  the

active moderesets the brightness level to full.

4. Color Selection slider

Directly selects color on the bar. To obtain white light only, keep the “Zone On”

(|)button depressed until the light changes to a steady bright white.

5. Mode Speed Increase(S+)/Decrease(S-)

Increases (S+)/decreases(S-) the tempo of the mode pattern currently active.

6. Mode Start/Scroll(M)

Modes feature different color combinations,  light transitions, and patterns, with

9 distinct modes.This button initiates the Mode function and scrolls through the

modes in ascending order.

7. Zone On(|)/Off(O) - Zones 1-4

Allows up to four “zones” (i.e. channels) of RGBW lights to be separately paired,

and controlledby the remote. Pressing one of the Zone On(|) buttons activates that

zone; commands will affectonly lights in that zone. Once paired to a zone, lights

remain paired until they are unpaired.Steadily depressing the Zone  On(|) button

restores the lights in that zone to white.

Wall touch panel remote

 

Important: In the first beginning, if you already have our portable RGBW remote that controls all your

RGB/RGBW lights  in your place. Don’t  need link/pair  your lights again when  you install this new  wall

touch panel. You just press  Button M over 5 seconds, the  wall touch panel goes to a “Learning  mode”

with the indicator flashing, then you press any button of the remote you have, the touch panel learn from

your remote while the indicator stops flashing, will control same lights as the remote in same way.

 

Pairing Lights to Remote Control

Pairing a Light to the Remote

1. Switch off the main power supply to the light.

2. Restore power and within 3 seconds, choosing one of the “Zone On” (|) buttons, depress the button. It will

flash white 3 times, indicating that the light is now paired to thatnumbered zone and can be controlled via the

remote.

Activating a Zone

To activate a specific zone, depress the “Zone On” (|) button. The zone is now active and remote commands

will only affect lights paired to that zone.

Unpairing a Light to the Remote

1. Switch off the main power supply to the light.

2. Restore power  and within  3 seconds, depress  the “Zone  On” (-) button  until the light flashes  10times,

indicating that the light has been unpaired.

An unlimited number of RGBW lights can be paired to a zone, and all lights paired to that zone will respond to

the commands  entered on the wireless  remote. Conversely, a  single RGBW light can  be paired to up to five

remotes. Note: The wireless remote operates using radio frequency. The remote controller’s use is not restricted

by normal obstructions  such as walls, doors, etc. Once  paired they can be installed anywhere  in range of the

remote (up to 100 ft. or 30m)

 

Specifications

Operating Voltage Range	100~240 VAC
Standby power	0.1W
Operating Temperature Range	-4~140° F (-20~60° C)
Maximum control Range	100 feet (30m)
RF Operating Frequency	2.4GHz
Surface material	Glass
Body Material	PC
Dimensions	80X80X39mm
Warranty	2years