Introduction of laser welding and electromechanical source of dual lamp pulse touch screen   

The switching power supply by the upper machine under the touch screen and A pulse power supply panel of two parts, the parameters of the pulse power source control is kept in touch memory, A total of 100 groups of discharge parameters, under A machine adopts series of 32 bit ARM CPU fast pulse power control, current control precision can reach 0.1 A, the power more stable. Touch screen page has 11 pages, turning the page on page 1 and 2 is mainly used to display manufacturer information, on page 2 stay after 10 s, automatically enter the monitor page, if in the second boot page want to immediately enter the monitor, can stay on page 2, press the touch screen anywhere, can enter the page of monitoring. Monitor, parameter, IO input, IO output, password page can be pressed by corresponding button, switch to each other. If you want to enter the parameter change password, the machine unlock password, the manufacturer sets the password, the system parameter password page, must first under the password page to enter.

Page switching diagram:

Touch screen appearance size and opening size

Appearance size (long X width X height) 226.5 mm X 163.0mm X 36mm

Aperture: (long X) 215mm X 152mm

See below:

 
Alarm message is: no boot, use period, ignition failure, charging detection fault, no pressure, flow, overheating, over-voltage, bus charging test, ignition signal detection, conduction time is greater than the cycle time, shutdown, LEM1 signal bolt, bolt LEM2 signal, power is too large, the normal work

Communication instruction: normal communication, communication error.

Single twin lamp indicator: no lamp, single lamp 1, single lamp 2, double light. Single - lamp power supply generally displays as single lamp 1.

Spot: the size of the spot.

Power: the discharge power set by the display parameter.

There are 14 points in the front of the welding product, which can improve the processing requirements.