Characteristic  

• 1, Ethernet interface supports MACH3 software, can be directly connected to the computer or connection router,          
• 2, simultaneously control 3 stepper motor linkage operation          
• 3, with 12 programmable input interface, can be configured with a limit of emergency stop function.          
• 4, with 10 programmable output interface, can be configured for water cooling, fog and cold.          
• 5, with 1 standard hand vein MPG interface.          
• 6, spindle PWM output control          
• 7, DCDC electrical isolation to enhance anti interference          
• 8, optocoupler input, prevent external interference in series          
• 9, the highest 200K stepper motor control pulse output, suitable for most of the machine system needs.          
• 10, exclusive design can be adjusted FRO, SRO, SJR parameters.          
• 11, anti interference is greater than MACH3 USB control card, hand control reaction rate and other significant increase.

Product Introduction

NVEMv1.1 is the 3-6 axis motion controller we spend 4 years to design.

NVEMv1.1 support Mach3 software and standard MPG,through Ethernet to communicate with computer,just use the Twine to connect directly or transfer with router.

NVEMv1.1 motion controller adopts the ARM design framework.The ARM design includes communication,codeanalytic,underlying algorithm and pulse gerneration. Rational design,reliablecontrol,convenient operation.

Products specification

• 12 ports photoelectric isolated input interface for ordinary digital data;
• 10 ports photoelectric isolated output interface for ordinary digital data;
• 1 port 0-10V spindle speed analog output interface(can change to PWM output);
• can support 3-6 axis stepper systems,200KHz pulse output for every axis;
• ARM motion control chip;
• main device is 12V-32VDC power supply input,current should higher than 0.5A;
• Compatible with MPG input,support the digital display MPG from our company;

Products Appearance an d struction and size
NVEMv1.1 motion controller is with the sealed shell structure,there are 4pcs setting holes at the bottom.We can fix 4pcs 4mm diameter holes at the cabinet,and install the controller into the cabinet.

The products overall size is:

163.1mm*80.8mm*27.8mm;

The bottom install size is:

101.4mm*42.5mm

Delivery list:          

1. Ethernet interface MACH3 control board(3 axis )X1        

2. cable X1