Control Motherboard MKS Gen V1.4 Compatible RAMPS 1.4 3D Printer Controls Board CLH@8

Description:

Features:
100% Brand new and high quality !
MEGA2560 and RAMPS 1.4 set on a board, to solve complicated RAMPS1.4 combination of interfaces, the problem of failure prone
Support up to 5 motor driver (A4988 or DRV8825)
The circuit board with high-quality 4-layer, heat and made a special optimization; ramps are 2 shelves
Using high-quality MOSFET, and better heat dissipation
Using a dedicated power chip, support 12V-24V power input, the voltage converter chip to solve the heat problem Ramps
Can accept 24V input power under the same system can be hot-bed current is reduced to 1/4, an effective solution to the hot bed MOS pipe heat problems
The firmware can use open source firmware Marlin, ramps1.4 identical configuration and can directly replace Ramps1.4
Can be directly connected to the control panel and 12864LCD Ramps1.4,2004LCD control panel
Reserved for motor pulse and direction output ports for easy plug-in high-current To add a large current (eg 2A, 5A) motor drive circuit
Reserved Ramps1.4 on Servos, AUX-1, AUX-2 interface that provides three 5V output, three 12V outputs
Notice:
Due to the different monitor and light effect,the actual color maybe a slight different from the picture color.
Please allow 2-3cm differs due to manual measurement .

Package Includes:

1 x MKS Gen V1.4 control board
1 x USB cable