| Motor Type: | Stepper Motor |
|---|---|
| Model Number: | controller |
| Unit Type: | piece |
| Package Size: | 13cm x 8cm x 8cm (5.12in x 3.15in x 3.15in) |
| Package Weight: | 0.2kg (0.44lb.) |
Quick Details
Specifications
- Product Name: simple stepper motor drive controller
This controller, the original function was unchanged, an increase of the function of the PWM signal can be generated, the board has a jumper to set selection, the default is set in the generation of the pulse signal frequency.
REQ provides pulse frequency signal
PWM is to provide the PWM signal
Length * width * height: about 73*51*37MM
Product description:
1, this module is the pulse generating module, the supply step driver as a signal. If you want to control the stepper motor, it must be equipped with the drive to go.
This simple controller + stepper driver + stepper motor + DC power supply can be composed of a set of simple control platform.
Now the controller has high, a total of 3 kinds of low frequency signal can be used to select frequency parameters about skipping, respectively:
High: 5.8KHZ-127KHZ
Medium: 590HZ-15.8KHZ
Low: 82HZ-2.3KHZ,
Measurement of frequency: PUL and (GND) two ports.
2, PUL- and PUL+ are positive and negative of the pulse; DIR- and EN+ are positive and negative EN- and DIR+ are positive and negative. Will these 6 lines are respectively connected to drive the corresponding pulse, direction, so that the 6 ports. Note that, if you want to open or stop function, the ENA controller must enable end is yin or yang to drive
3, 2sets of power input, the 2 group is only connected to a set of power.
One group is the power supply to the DC 15-160VDC.
The other group is 5-12VDC. If it is powered by 5-12VDC, the power supply is connected to "5-12V", and the power supply is negative ".
4, the motor is rotating, reverse, open, close, you can control the key to control.
5, the speed of the motor can be controlled by adjusting the potentiometer to change the frequency.
6, the motor is the reverse switch and the switch is the ordinary with the switch.
Note: please do not take the wrong line, may burn the driver
If you want to switch on the chassis panel, you can contact me, I will give you method.