5 axis breakout board

1. full support for MACH3, KCAM4, EMC2, and support parallel port to control the host computer software;

2. 5 output signal ,can connect with 5 stepper motor driver ;

3. 4 input port, Can connect to the limit switch, emergency stop, or other Input devices ,5 input signal indication LED;

4. One relay, it can be used to control spindle start and stop;

5. Interface board built-in 5V power converter chip, can be connected with DC 12V-60V power supply, power can be shared with the driver.

 

 

ST-M5045 driver

1. Technical Parameter:Supply Voltage: 24~50V DC (Typical 36 V).
2. Output Current (peak): Min 1.0 A, max 4.5A.

3.Supports Fourteen sub select, up to 256 Subdivision;

4. Logic Input Current: Min 7, typical10, max 16 mA.
5. Pulse Frequency: Max 200 KHz.
6. Pulse Low Level of Time: 2.5 US.
7. Cooling: Natural /mandatory.
8. Working Surrounding: Avoid dust, oil mist and corrosive gas.
9. Storage Temp: -10---80 deg.
10. Working Temp: Max 65 deg .
11. Surrounding Humidity: <80%RH without condensing and frost.
12. Vibration: 5.9m/s2.
13. Model: ST-M5045.

 

 

stepper motor

Model	JK57HS112-3004
Number of phases	2-phase
Number of lines	4-wire
Phase voltage	4.8v
Phase current	3A
Torque	2.8N.M(425 Oz-in)
Shaft Diameter	8mm
Axial length	21mm
Side length	57mm
High	112mm
Weight	1680g

 

 

RED: A+

BLUE: A-

GREEN: B+

BLACK: B-

 

Switching power supply

1. the range of AC input voltage is changed by the switch
2. high-efficiency, high reliability

3.100% full load burn-in test

4. Protections: Short circuit / overload / over voltage / over temperature

5. built-in cooling DC fan control

6. Working frequency is 25 kHz

7.Input Voltage:220V

8. Output Voltage:36V

9. Output Current:9.7A

10.Output Power:350W

11. 1 year warranty