New TB6560 USB CNC Controller 4 Axis Nema23 3.0A Stepper Motor USB Driver Board

1. General introduction

This USB6560T4 is a new 4 axis TB6560 CNC control board with USB input, suitable for controlling max.3A 2 phase stepper motor.
It's easy to operate for CNC DIY, but as it's controlled by USB port, users need more careful with the software install.

2. Features:

1) 4 axis in one unit, easy handling with PC, power supply & motors.

2) 4 decay modes, suitable for 2 phase stepper motor with no more than 3A current.

3) The software designed for this board, can support maximum 8pcs limit switches (Every axis with 2 pcs), much better than Mach3.

4) When connected with manual control box, the board can work off-line, good for coordinate adjusting on tool setting part.

5) 4 current setting: 0.75A, 1.5A, 2.25A, 3.0A.

6) Automatically reducing current on board, when stepper motors were forced to stop, the current on board will be 25% of full current to protect the motor and IC chips.

7) 12V isolated power supply output easy for external application, like cooling fan.

8) Limit port is optical isolated to protect IC, also it's with 12VDC input, easy for connecting with proximity switch.

***NOTE:
This driver board is controlled by USB port, can only use with the CNC software special designed for this board. It can't be used with MACH3, KCAM4 or other CNC softwares.
Users should follow its manual and install the software correctly.

4. Configuration and pictures of the items

 

 

 

 

• CNC 4 Axis USB control card * 1
• USB cable * 1
• CD * 1