| Motor Type: | Stepper Motor |
|---|---|
| Unit Type: | piece |
| Package Size: | 18cm x 15cm x 12cm (7.09in x 5.91in x 4.72in) |
| Package Weight: | 1.0kg (2.20lb.) |
Quick Details
Specifications
Package Includes
1xTB6560 triaxial interface board
1xInterface cable
Product Description
1, the working voltage DC 12V-40V
2, applicable software mach2, mach3, KCAM etc.
3, the output of a standard three-axis drive, and set aside a fourth / five-axis expansion and stop limit on the knife port, user-friendly expansion of freedom.
4, the control section and driving section high-speed optical coupling completely isolated. Prevent mutual interference, coupled with the parallel port connected to the computer after the host, most hosts leakage, greatly interfering signal isolation can effectively be avoided.
5, parallel signal is weak, the output level of instability, different motherboard level voltage output is also mixed. The driver board using imported 74HC series chips for parallel signal amplification shaping, the output level to improve performance and stability, to avoid stepping out of step, unresponsive happening.
6, the stepper motor drive with a new original Toshiba TB6560 chip inside is a dual H-bridge DMOS, and (FET) wiring must be noted that any mistake with the wrong line over a short-circuit can cause burn chips.
7, the maximum rated output: ± 3A, 40V, Peak 3.5A, low output impedance, the source 0.5Ω, the receiving end 0.4Ω, low voltage shutdown, thermal parking protection.
8, 57,60,86, etc. for the stepping motor within 3A, 3A is not suitable for more than a stepping motor.
9, automatic half flow attenuation.
10, breakdown: full step, half step, 8 segments, 16 segments.
TB6560AHQ two-phase hybrid stepping motor driver chip, built-in duplex bridge MOSFET drivers, temperature protection, voltage 40V, current 3.5A (peak), 16 segments.