Motor Type: | Stepper Motor |
---|---|
Model Number: | cnc kit 4 axis |
Unit Type: | Set |
Package Size: | 32cm x 16cm x 16cm (12.60in x 6.30in x 6.30in) |
Package Weight: | 1.5kg (3.31lb.) |
Quick Details
Specifications
Diy CNC Kit 4 Axis Stepper Drive 2M542 4.2A &
Breakout Interface Board for CNC Machine
Part 1: CNC Stepper Motor Drive 2M542
Key Features:
- 20 to 50VDC Supply Voltage
- H-Bridge, 2 Phase Bi-polar Micro-stepping Drive
- Suitable for 2-phase, 4, 6 and 8 leads step motors, with Nema size 16 to 34
- Output current selectable from 1.0 ~ 4.2A peak
- Current reduction by 50% automatically, when motor standstill mode is enabled
- Pulse Input frequency up to 200 kHz
- Optically isolated differential TTL inputs for Pulse, Direction and Enable signal inputs
- Selectable resolutions up to 25000 steps
- Over Voltage, Coil to Coil and Coil to Ground short circuit protection.
Introduction:
2M542 is a cost effective, high performance bi-polar two phase micro-stepping drive applying pure-sinusoidal current control technique. It is best suited for the applications that desired extreme low noise and heat. It operates well in an environment, where electricity supply experience instability and fluctuation.
The general pseudo-sinusoidal current control technology adopted by majority of the drive produced distorted sine wave, and current ripple, resulting in vibration, noise and motor heating. This results in motor degrading over time, reducing in motor performance and shortens the usage life.
With an automatic optimization speed control technique, the PowerStep series drive output is very stable, with almost zero vibration and noise, performing close to a servo system, allowing the motor to operate smoothly. That helps to fulfill a design requirement of low noise, low heat and high performance.
Specifications
Parameters Min Typical Max Unit
Output Current (Peak) 1.0 - 4.2 Amps
Supply voltage 20 36 50 VDC
Logic Input Current 7 10 16 mA
Pulse input frequency 0 - 200 KHz
Low Level Time 2.5 µsec
Part 2: CNC 5 Axis Interface Board
Feature:
1: The maximum matching 5-axis stepper motor driver
2: The two-stage signal processing, signal transmission smooth, powerful anti-jamming
3:5 input interface to define the emergency stop, limit, points in the knife, etc.
4: relay output control interface, can be accessed by the spindle motor or the air pump, water pump, etc
5: five-axis job LED display, visual display products, working condition
Electrical performance (Tj = 25Degree ambient temperature when):
Input Power 5V DC power supply or computer USB to take power
Work axis stepper Received the highest 5-axis independent driving
Drive Pulse + direction + enable signal.
Weight About 200 grams.
Interface definition table:
Power output interface function:
Interface, detailed drawing marked:
In the test machine, note the following before
1, note that using the 5V power supply
2, determine the stepper driver works (Model0)
3, to determine the drive wiring step
Package included:
4 x stepper drives 2M542
1 x CNC 5 axis interface board
1 x Cable