Stepper motor drive control machine 42,57/stepper controller/drive control/fixed-length round trip

 

.   Controller operation: 

Controller, digital display " Sto, The stopped state.

When you start input signal, the controller starts to run, running, show run

When the stop input has signal, the controller runs until the mid-point stop, display Sto

.   Parameter settings:

P01 : Set motor speed, 3-200 mm/s, the default value of 100 mm/sec.

P02 : Set the reverse delay time during operation, and 0.0 to 9.9 seconds, default 0.1 seconds

P03 : Run length setting (screw-thread pitch for 10MM conversion), 1-999mm default 70mm on duty

P04 : Motor current setting, 0.2-1.6, default on duty 1.6 actual current value = set *2.5

P05: Set motor speed control, 0-9,0 accelerate the fastest, slowest 9, the default value of 5, will accelerate slowly, such as motor starting, set according to the actual situation

In the stop State, press the "SET" key led display "P01", press > set P01 key parameters,

NIXIE tube display of parameter P01 will be on duty, and the first led flashes, press > keys to select settings, press ^ to modify settings, press the "SET" button to confirm, modify the parameters and digital display "P01", and then press the "SET" key to display the P02,P03, set the parameter P01, press "SET" key set P04,P05 parameters that appear.

To drive the motors of the 42BYG,57BYGH,57BYG series, the maximum current 3.5A, the largest subdivision adjustable 64, button configuration, NIXIE tube display.