| Model Number: | M415B |
|---|---|
| Motor Type: | Stepper Motor |
| Voltage: | 24V |
| Power Supply: | DC |
| Unit Type: | piece |
| Package Size: | 10cm x 10cm x 10cm (3.94in x 3.94in x 3.94in) |
| Package Weight: | 0.35kg (0.77lb.) |
Quick Details
Specifications
New Leadshine M415B Stepper Drives work 24V-40 VDC out 0.21A to 1.5A Fit for Setpper motor NEMA 16or 17 size model 39HS02/42HS02
Features:
- High performance, low cost
- Supply voltage up to +40VDC
- Output current up to 1.5A
- Inaudible 20 KHz chopping frequency
- TTL compatible and optically isolated input signals
- Automatic idle-current reduction
- Mixed-decay current control for less motor heating
- 7 selectable microstep resolutions: 1, 2, 4, 8, 16, 32, 64
- Suitable for 2-phase and 4-phase motors
- Protection against power leads(+, -)reversal
- Small size: 86*55*20mm (3.386*2.165*0.787Inch)
Introduction :
The M415B is a very small size high performance microstepping drive based on one of the most advanced technologies in the world today. It's suitable for driving any 2-phase and 4-phase hybrid stepping motors. By using advanced bipolar constant-current chopping technique, it can output more speed and power from the same motor, compared with traditional drives such as L/R drives.
Specifications :
General :
Electrical Specifications (Tj = 25oC/77oF)
| Parameters | M415B |
| Supply voltage | +15 to 40 VDC |
| Typical supply voltage | +24-+36 VDC |
| Output current (Peak) | 0.21 to 1.5 A |
| Microstep resolutions | 1, 2, 4, 8, 16, 32, 64. |
Connector P1 Configurations
| Pin Function | Details |
| PUL | Pulse signal: This input represents pulse signal, effective for each rising edge; 4-5V when PUL-HIGH, 0-0.5V when PUL-LOW. For reliable response, pulse width should be longer than 1.5ms. Series connect resistors for current-limiting when +12V or +24V used. |
| DIR | Direction signal: HIGH/LOW level signal, correlative to motor rotation direction. For reliable response, DIR must be ahead of PUL by 5ms at least. 4-5V when DIR- HIGH, 0-0.5V when DIR-LOW. Motor rotation direction also depends upon the connection of the motor windings, exchange any motor phase can reverse motor rotation direction. |
| OPTO | Opto-coupler power supply, and the typical voltage is +5V. |
| ENA | Enable signal: This signal is used for enabling/disabling drive. High level for enabling drive and low level for disabling drive. Usually left unconnected (enabled). |
Connector P2 Configurations
| Pin Function | Details |
| Gnd | DC power ground |
| +V | DC power supply, 15~40VDC, Including voltage fluctuation and EMF voltage. |
| A+, A- | Motor Phase A |
| B+, B- | Motor Phase B |
