CUT to LENGTH LINE MACHINE
             
1.Rang of work
Thickness: 0.23 - 0.35mm
Width: 60 - 640mm
Length: 600 - 3500mm
2.Require for coil
Width tolerance: 0.1mm
Burr: 0.03mm
S deviation between: 2000mm, 0.2mm
Material wave: Local wave height 1mm
Material shall have no rusty spot, Thickness deviation 0.02mm
3. Precision
Length tolerance: 0.2mm
Angle tolerance: 0.025
Burr: 0.02mm
the key technology and innovations
1,Adopt the most high-end dedicated Simotion-D425/D435 controller in Simens motion controller.Voltage command type servo system,the maxium response speed to 4000000 pulses per second,the speed up to 240 meters per minute.It can realize the multi axis linkage,electronic cam control mode,high speed shearing.
2,Feeding machine adopts center positioning structure
the production line is to change the traditional feeding machine unilateral (fixed) positioning structure layout,use more reasonable advanced center positioning structure layout.the structure can effectively avoid the feeding and discharging unilateral partial load problem,greatly reduces the sheet into pointed phenomenon,to ensure product quality,improve the production line running stability.
3,Feeding motor/punch motor and shearing machine use linkage control cutter use Siemens servo motor drive.
O punch and V notch can through servo motor to realize the horizontal,verticle movement and in the movement can realize high speed cutting;
the machine use nine servo motos to control,and through Siemens Simotion-D435 movement to realize nine shaft linkage of control.
4,Buffer pithead technology
this technoligy use high accuracy ultrasonic non-contract Synchronous measurement technology,more material detection,feedfoward Synchronous feeding algorithm and other technology,ensure the production line of the high speed and stable operation.The application of this technology,through the servo motor and servo control system,conbined with the corresponding mechanical device,driving in the production line of punch,shears complete controllable cutter.The technology to solve the pneumatically driven can be cut to the users in equipment foundation construction cost saving.