fully functional Serial ATA Host Controller PCI card, which supports Data Transfer Rate up to 1.5Gbps. PSA-150 is compliant with Serial ATA specification Revision 1.0 and PCI Specification Revision 2.2. -------------------------------------------------------------------------------- Features: Compliant with Serial ATA Specification, revision 1.0 Provides two independent channels to connect up to two Serial ATA hard disk drives Supports Serial ATA data transfer rates up to 150MB/sec Features independent 2560byte FIFOs per channel for host reads and writes Breaks the 137GB barrier! Supports various brands of large capacity Serial ATA hard disk drives Flexible Serial ATA cable is easier to route inside a PC System Requirement: IBM-Compatible PC with 600MHz or faster processor Microsoft Windows 98SE, Windows ME, Windows 2000 or Windows XP Available PCI slot Floppy or CD-ROM drive Specification: Silicon Image SiI3112 SATALink PCI Host Controller Compliant with Serial ATA Specification Rev. 1.0 Compliant with PCI Specification Rev. 2.2 Compliant with PCI Bus Power Management Specification Rev. 1.1 Port type: Two Serial ATA ports Slot type: 32-bit PCI Provides two independent channels to connect up to two Serial ATA hard disk drives Supports Serial ATA data transfer rates up to 1.5Gbps Features independent 256-byte FIFOs per channel for host reads and writes Supports 32-bit wide PCI bus at 66MHz Lower pin count and voltage requirement, plus better cabling over traditional Parallel ATA make Serial ATA the controller of the future Package Contents: One Serial ATA PCI board One Serial ATA cable One Serial ATA driver CD Quick Installation guide