Automatic fire hose box roll forming machine for production different size cabinet 

Shenzhen Superda Machine Co., LTD Roll Forming accuracy
A. Shear length tolerance: ≤±0.3mm/m
B. Width tolerance: ≤± 0.3mm
C. Sickle bending: ≤2mm/m
D. Burr: ≤0.1mm (new cutting edge cuts carbon steel plate in reasonable clearance)
E. Height tolerance: ≤±0.3mm
above tolerance with flat edgeless one-stage steel coil as a prerequisite.
Surface quality: the surface of the finished product after processing does not add any processing defects.


7. Other parameters of the equipment
A. Power supply: 380V/50HZ/3PH, can customized as per user country.
B. Installed capacity: about 31kw.
C.Forming speed: 0-13m/mind.
D.Shearing method: Servo front shear
E. Drive motor: Unwinder motor 4KW.
 leveling motor 2.2KW.
Hydraulic punching cutting and hydraulic tensioning motor (two sets) 11KW+7.5KW. Forming main engine 5.5KW.
Servo motor 2KW
F. Floor area (approx.): length 24m width 3m (host specification 7mX1.7m)
G Production line direction: from left to right (on the console facing the unit).
H. Equipment color: (customer selection)
I. Superda fire house box equipment design can meet 12 hours of continuous production
J. Operating environment
1: Power supply voltage: 380V ± 10% / three-phase four-wire,frequency: 50HZ Total power: about 31KW2: Environment Temperature: 0-40 ° C, relative humidity: 60-95% RH.

 production line

Roll forming machine for production fire fighting box, fire house box, fire safety equipment box, fire hose cabinet.

1,Metal Forming machine for fire hose box panel and bending

No.	ITEM		PARAMETER	REMARK
1	MATERIAL	Type	Cold-rolled strip steel, galvanized sheet
		T.(mm)	0.8-1.5mm
		Yield Strength (Mpa)	Q235
2	Forming product   Width		255mm
3	Forming speed   (m/min)		3-16m	Including hole
4	Forming main power   (KW)		7.5 KW	FYR
5	Hydraulic power   (KW)		18.5 KW	FYR
6	Bending power (KW)		3 KW	FYR
7	Voltage		AC380V,50Hz,3P

 

4, Fire box Roll Forming machine list

(a), 2 in 1 Uncoiler   straightener

(b),Servo Feeder

(c), Hydraulic hole punching system

(e)Main Forming machines 

5.1  Forming Roller:20 stations,and add Rub-roll, to make sure the surface profile no scratches.5.2  Side Panel:T.18mm,A3 steel   Heavy duty.

5.3  Rolling speeding: 2-8 m/min.

5.4  Roller material:GCr15,overall quenching, hardness HRC56-62 ℃. 
5.5  Motor power:7.5KW.    
5.6  Main Roller:dia.75mm,45 #.
5.7  Equipment base: 45 # H type using welded steel plate.