Elastic Caps for Cup Electrodes


[Main Structural Composition]

Its shape can be in the form of binding that to provide binding force to wound dressings or limbs, and play the role of bandaging and fixing.Some of them are elastic or self-adhesive.Non-sterile, no direct contact with the wound, adhered to the site of intact skin.

[Product performance]

1.the head circumference deviation of the product shall be within ± 2.0 cm;

2.Based on international 10-20 postion system, the deviation of electrode position is less than 0.2cm;

[Scope of application]

to provide binding force to wound dressings or limbs, and play the role of bandaging and fixing.

[Contraindication]

Use of this product is prohibited for those who have not healed after head and face surgery.

[Notices, Warnings]

Choose the right size cap before use.Otherwise, EEG signal acquisition will be affected

[Useing instructions]Elastic cap (C type)

1Cleaning the head skin of subjects

2The elastic cap is putted on the patients'head and fixed on the correct  electrode position, it needs to make sure that every electrode is touched perfectly  with the head skin.

3.Connect the connectors of the electrode wire to the electroencephalograph through an amplifier

4Connect the electroencephalograph to an output device, such as a printer, and turn on the power supply.

5Start testing, recording and printing test results

6Remove the EEG template shell and electrode wires after recording and help patients to clean.

7Clean the EEG template shell with clean water and dry it in shade.

 

[Useing instructions]Elastic cap (B type)

1Cleaning the head skin of subjects,putting the install bridge electrodes on cap.Putting the finished cap into 0.9% saline for 10 minutes, using towel to wipe out saline that on the cap surface to prevent the saline to corrode  patients'neck

2.Fixing the alligator clip to the bridge electrode on template shell and adjust the EEG template shell to make sure each electrode contacts the scalp vertically.

3Connect the other end of the electrode wire to the electroencephalograph through an amplifier

4Connect the electroencephalograph to an output device, such as a printer, and turn on the power supply.

 

5.Start testing, recording and printing test results

6Remove the cap and electrode wires after recording and help patients to clean

7Clean the cap with clean water and dry it in shade