Nail Making Die for Common Nail Making Machine

Product introduction:

Nail Making die as one part of Nail making accessories, there are different shape, different Angle. this die is one kind of Common Nail making machine wear and spare Parts.   these dies hold the wire tightly in place, whereas the free-end wire is hit by 

Mechanical hammer, which causes deformation of wire within die-cavity forming 

Head of nail.  Similarly, with the wire still clamped in dies, shaped cutters hit the 

Opposite end of nail, forming point and later cutting the nail from the residual 

Wire-coil. Finally, the dies open and an expelling mechanism push the nails into 

Collection pan. the whole cycle is again repeated for making more nails.

Product  Parameter:

Grade	Equal to  ISO	Density (g/cm3)	TRS (N/mm2)	Harness (HRA)	USE
YG15	K40	14.0	2300	86.5	for fabricating Drawing dies of steel tubes and rods under high compressibility ratio; punching Stamping forging tools under large stress.
YG15C	K40	14.0	2500	85
YG20	K40	13.5	2400	84	for various Dies made by cold forging, cold stamping and hot forging.
YG20C	K40	13.4	2600	81-82	Dies for wear Resistant or impact resistant application