Can bus LED

Model:211A2W-3030

Lumen:130lm

LED QTY: 2pcs ultra bright smd3030

Voltage: 12V DC (that is, the output voltage of a normal car)

Current:0.12A

Wattage:1.44W

Dimension:12.49*31mm/36mm/39mm/41mm

Weight:3.8g

Uses: reversing lights, turn signals, reading lights, license plate lights, door lights, tail box lights, foot lights, etc.

Available colors: white light, blue light, red light, yellow light, green light

World LED Car Bulb Material advantage:

1.High power LED beads are from USA KERUI,Netherlands Feilipu,Germany and OUSILANG. SMD beads are from Taiwan Jingyuan.

2.the resistor,capacitance and electrical inductance,it is imported from Japan Murata and TDK.

3.Driver constant IC are imported from PI/TI USA PT4205.

4.We use 70mil big IC rectifier bridge which imported from Japan Murata and TDK.

5.Diode are used from Taiwan military level SS54.

6.We use double painted aviation grade aluminum PCB on high power LED car

Bulb,like Kerui,Feilipu.and double painted fiberglass PCB on low power LED car bulb.Aluminum aviation grade PCB thickness is 2mm.Fiberglass PCB thickness is 1.6mm and 1mm.

7.We use gold wire pure copper bracket lamp beads.High efficient heat dissipation.

8.We use the most expensive thickening red copper as 1156/1157/BA9S socket.

9.Lens are HD high temperature resistant spotlight lens.

10.T10/T20/T25 socket are high temperature resistant plastic base.

Light source:

1. the product adopts imported SMD chips, and the ultra-thin board shape design makes the installation and fit better, the illumination is more uniform, and avoids the disadvantages of poor illumination width caused by the point light source; this SMD product has the characteristics of light diffusivity, wide-angle illumination and high lumen;

2. No delay in lighting, high light purity, strong color rendering and penetrating power;

3. Using LED light-emitting diodes, low power consumption, can better protect the car circuit;

4. LED has no filament, good heat dissipation, low current, low heat, and the vehicle circuit is not easy to oxidize;

5. Strong shock resistance and low temperature rise, it is a new generation of revolutionary solid-state light source;

6. Suitable for DC 10-13V.

[Product Note]:

No need to modify the circuit, directly replace the original traditional glass bulb, pay attention to the high temperature of the original bulb to prevent burns!

When installing, refer to the product dimensions and pay attention to the size of the installation location. Press carefully and do not squeeze the LED chip to avoid damage. If the LED has positive and negative polarity, if it is not on, turn the direction and reinstall;

[LED Features]:

1. It can directly replace the traditional tungsten bulb of the original car;

2. the LED has high luminous purity, no need for lampshade filtering, and the light wavelength error is within 5 nanometers

3. There is no delay when the LED lights up, while the traditional tungsten bulb has a delay of 0.3 seconds.

4. LED has low power consumption. When it reaches the same brightness of traditional bulbs, it consumes only 6% of traditional bulbs, and it also saves electricity and fuel!

5. It has a long life, its filament-free structure does not generate heat, and it can be used for more than 6 years under normal conditions

6. LED car lights can make the vehicle control circuit not easy to oxidize, with a maximum load current of 0.1A.