| Brand Name: | ANSEN |
|---|---|
| Properties: | Medical Polymer Materials & Products |
| Feature: | Waterproof |
| Type: | Orthopedic |
| Material: | Fiberglass |
| Product name: | Fiberglass casting tape |
| Place of origin: | China |
| Material: | fiberglass impregnated with polyurethane resin |
| Color: | white, black, green, yellow, military green, etc |
| OEM Service: | support |
| Sample: | free offered |
| Width: | 5cm,7.5cm,10cm,12.5cm,15cm |
| Length: | 360cm |
Quick Details
Specifications
Product Structure and Application
[Contains]:Polyester or fiberglass, polyurethane. Applicable to common plastic surgery. It is used to provide binding for wound dressing or limbs in order to make a binding up and fixation effect.
[Product Features]Ansen cast has many advantages, such as high strength, light weight, curing rapidly, air-permeability, x-ray radiolucent, easy operation, comfort and safety, less dust during remove, etc.
[Attention]A.Check bag,any breakage, even pinhole will bring curing of cast
B.Open one bag at a time, and operation the cast immediately Don't open multi-bags at the
SameTime to avoid weakening the strength.
C.Operation by professional doctor.
D.Disposable products. after use, treat as medical waste.
[Storage]Stored in a cool dry and ventilated atmosphere. the proper temperature is 15°C- 30°C and the humidity should be less than RH60%
[Date of manufacture]Mark on package
[Expiry date ]Shelf life is 2 years
[Specifications ]Mark on package
A.Wear surgical gloves, select the roll of proper size. Apply stockinette or protective padding over the affected body part.
B.Open the package, immerse the roll of cast in room temperature water (21°C -24°C) for 4- 6 seconds, and squeeze 2- -3 times to complete penetration of water into the roll, take it out and squeeze water off.(the temperature of water is proportional to set time. the higher temperature shorten the set time, while the lower temperature lengthens it Temperature of water warmer than 27°C,obviously shorten the set time,hardly for the surgery.)
C.Wrap cast spirally, overlapping the previous layer by one-half or two-thirds the width of the roll Keep the proper tension and take care to avoid excessive tightness Excessive looseness will reduce the adhesion between layers, excessive tightness will affect the blood circulation of injured parts.(the strength can be determined by the number of layers used the more layers, the stronger. Just 3-4 layers provide a strong non-weight-bearing cast and 5-6 layers are typically adequate for weight-bearing cast. Additional layers need to keep a proper adhesion.)
D.Smooth and rub the surface to achieve good contact between layers. Finish the whole operation in 3- 5 minutes. (Overtime will affect the adhesion and molding., Injured parts cannot move before the sufficient cure of cast.)
[Tip]Cast trimmed or removed with electric plaster saw equipment.
