Performance

 Capacity:8-1400m3/h

 Head:5-135 m

 Inlet oUtlet diameter:50-350mm

Product advantages

High-efficiency energy saving: All pumps are used domestic advanced computer hydraulic model software and optimized design, performance advantage is obvious,the efficiency is 2-3% higher than similar products to save more energy,and wide high efficiency area

Equipment reliability:Absolute concentricity of pump shaft and excellent static and dynamic equilibrium of impeller,ensure the pump running at high speed with low vibration,low noise

COnvenient installation, maintenance:Pump shaft and motor shaft are rigidly connected, easy separating and maintaining between motor and pump, the pump can be installed in any position and direction of the pipeline,simply open the pump cover for repair

Low maintenance: Reasonable structure,convenient assembly and disassembly, and simple maintenance

Special design:as required, the flow channel can be used the US high temperature enamel technology to improve efficiency and durability

Ordering instructions

1.Please provide the following information when placing an order

Pump mode or required operating conditions point flow:head and cavitation allowance and other parameters

Physical or chemical properties such as temperature,corrosiveness,etc

Pump inlet pressure

Shaft seal type(if the use of packaged machine seals,special notes,do not indicate the supply of ordinary mechanical seals)

Direction of rotation(the pump is: viewed from the motor end,the pump is selected clockwise)

Parts material(Supply according to standard configuration if not indicated)

Motor power,voltage,protection level,insulation level,cooling mode,whether explosion-proof and other configuration requirements

2. Model selection instructions

the order is not limited by the performance parameters list.Data in the catalogue is only special point parameter,we can design and manufacture the product according to the user requirements

the parameters proposed by the user should be near the maximum efficiency point of the sample curve,and the pump type with a flow rate between 0.7 and 1.1 times the maximum efficiency point should be preferred,and the use parameters should not be greater than 1.1 times the flow rate of the maximum efficiency point.

the water pump can run at a reduced speed,if 60Hz motor is used,please contact our product engineer for confirmation