Ultra-low pressure permanent magnet frequency conversion, big host, low speed, large displacement, advanced separation system, cleaner gas, high-end customization 

1. the pressure setting of frequency conversion air compressor can be one point, that is, the minimum pressure that can meet the requirements of production equipment can be taken as the setting pressure. the frequency conversion air compressor will adjust the speed of the air compressor according to the trend of the pipe network pressure fluctuation, and even eliminate the unloading operation of the air compressor, saving energy.  

2. Because the frequency conversion air compressor makes the upper and lower pressure of the pipe network stable, it can reduce or even eliminate the pressure fluctuation, so that all the air compressors operating in the system are operating under a lower pressure that meets the production requirements, reducing the power loss caused by the upward pressure fluctuation.  

3, because the compressor can not be ruled out in the state of full load for a long time, so the capacity of the motor can only be determined according to the maximum demand, so the design capacity is generally large. in practice, the proportion of time spent on light loads is very high. Such as the use of frequency conversion speed regulation, can greatly improve the working efficiency during operation. Therefore, the energy saving potential is great.  

4, some adjustment methods (such as adjusting the valve opening and changing the Angle of the blade, etc.), even in the case of small demand, can not reduce the operation power of the motor. When the demand is small, the speed of the motor can be reduced, and the operating power of the motor can be reduced, so as to further realize energy saving.  

5, single motor drive system can not be adjusted continuously according to the weight of the load. after using frequency conversion speed regulation, it can be very convenient for continuous adjustment, can maintain the stability of pressure, flow, temperature and other parameters, so as to greatly improve the performance of the compressor.