307 Light Polyester Putty Ingredients: Unsaturated polyesters resins, modified resin, color pigment, stuffing, anti sediment materials, auxiliary agent and firming agent mixing ratio 100：2. The ash is exquisite and has excellent construction performance, which can well tamp the sand holes left after rough scraping with polyester putty. Also, polyester putty finely scraped enjoys quick drying, good sanding property and adhesion. It is mainly applicable to the filling and leveling up as well as decoration of the deficiencies such as sand holes, pinholes and shrink holes on the surface of polyester putty before closing the undercoat in the painting dressing of cars, so as to strengthen the flatness and smoothness of the surface of polyester putty. And it meets the requirements of flatness and smoothness etc. on the appearance of top coating. Main technical standard: Item Index Testing Standard Outward appearance The color is unanimous, and there are no visible particles by naked eye, and being rather exquisite Visual examination Air drying Meet the customers?requirements GB/T1728-79 Consistency 9-12cm (except for the specialities) GB/T1749 Scratching performance Good handling, no curling Burnishing performance Burnishing easy, extraction powder is fast. Resistance to high temperature There is no bubbling and cracking under baking at 120℃ after drying There is no bubbling and cracking under baking at 80℃ after gelling Pliability ≤50mm GB/T1748 Impact Strength ≥13kg.cm (or 35kg.cm Not falling off) GB/T1732 Adhesive force ≥65Kg/1.2cm2 GB/T5210 Reference for construction: 1、 Evenly mix the main ash and firming agent with the proportion being 100：2 (make the color unanimous), and using up them within the gelation time. 2、 Scratch the putty which has already finely mixed on the primer paint of double components after burnishing or the surface of cold-rolled sheet which has already been finished processing. If the thickly scratching is required, you抎 better thinly scratch for many times to meet the required thickness. If some air bubbles infiltrate while scratching, you should thoroughly strickle it by means of scraper, so as to ensure the good adhesive force. The best wet milling time is 0.5-1h after scratching (As for wet milling polishing, paint-spraying should be done after the water vapor dries out).2-3h is the best dry milling time. Notes: 1、 Cover it after using in case that the impregnant volatilization may result in the deterioration of main ash. 2、 The solidifying period of coating film will extend if the temperature is high or low. The consistence and gelation time (pot life) of putty may adjust according to the requirements of customers? 3、 This product is unsuitable for directly scratching on galvanization plates.