Specification:
Power Sources: 220~240V/AC
110~130V/AC
Power Frequency: 50~60Hz
Ambient Light: 10Lux~sunshine (adjustable)
Rate Load: 40W,(60W Max) (230V/AC)
Detection Distance: 9m(Max)
Detection Range(22℃): 110?140?200?
Time Delay: 5Sec~8?Min(adjustable)
Work Temperature: -10~+40℃
Installation Height: 1.5m~3m
Working Humidity: ≤93 %RH
ST81 moistureproof lamp using
instruction
General:
This product is a kind of energy-saving automatic lamp ,it can turn on when one comes and turn off after he leaves, It can identify day and night automatically. It adopts infrared energy discharge detector and integrated circuit. its performance is stable. The lamp will be on when one enters the detection field and trigger it, and it will be off after one leaves
Function:
1.Can identify day and night automatically, the working ambient light can be adjusted freely, it can work automatically at night and stop in the daytime,
2.The illuminated time can be delayed automatically and adjusted according to the customer抯 desire.
Specification
Detection range(22℃): 140?
180?
200?
Detection distance: 9m(max)
Power sources: 220~240V/AC
110~130V/AC
Power frequency:50~60Hz
Rate load: 60W max (230V/AC)
Time-delay: min:8sec+3sec
max: 3Min+1Min
Ambient light: 10LUX~sunshine
Installation height: 1.5m~3m
Working temperature: -10℃~+40℃
Working humidity:≤93℅RH
Installation:
Connect wire according to the figure when installing.
The specific installation way:
Select the installation position correctly according to the following detection diagram;
Loosen the fixing screw of lampshade, take off protection net (protection shade) and lampshade;
According to connection-wire figure and mark, connect power;
Install detection lamp on the selected position according to the installation figure;
Cover lampshade and protection net; tighten the screw and then electrify it.
Test:
After installing, turn the time knob anticlockwise to minimum before electrifying, turn light-control knob to daytime anticlockwise;
The load should work after the first electrifying for 5S, then it stops , make it induct again within 30s, the load should work again.
If all ar
