Coaxial Connections series signal protectors are designed for protection of communication network circuits, which are sensitive to electromagnetic interference, avoid destruction result from lightning over-voltage, induced over-voltage and static discharge. MAIN FEATURE: Multi-Protection circuits, low residual voltage. Large discharge current and quick response. Superior transmission performance. Excellent technics and long life even in bad circumstance Convenient installation. PARAMETERS Model LD*10K05 LD*10K24 Continuous operating voltage Un 5V 24V Nominal discharge current (8/20μs) In 5kA Max. Discharge Current (8/20μs) Imax 10kA Protection level Up 8/20μs Line~Out-conductor ≤30V ≤60V Out-connductor ~Grounding ≤100V Output Voltage threshold at 1kV/μs ≤700V Adapt transmission rate 10Mbps Insertion Loss ≤0. 5dB Respond time 1ns Dimensions 58mm *26mm*26 mm Working environments Temperature -25~+65, Humidity relative≤95% (25), Altitude≤3km '*' for connector type: Connector Type BNC SMB N TNC NEC L9 CC4 F B S N T E L C F '#' for I/O mode: I/O mode Male / Male Male / Female Female / Female Female / Male INSTALLATION: Connect in series between protected equipment and signal channels. Should install close to the protected equipment Connect IN-port to signal channels and OUT-port to protected equipment. Connect lead to grounding bar dependably. No special maintenance needed. If malfunction occurs in operating system, please remove the protector, and then check the system. If system recovered, that means the protector has been damaged and must be replaced.