1) Input specifications: a) Input voltage: 110-230V AC 5% (90V AC - 264V AC) b) Input frequency: 50 / 60Hz 10% (45Hz-66Hz) c) Fuse: A fuse is included in the AC line circuit. The fuse rating is as to prevent hazard in the event of an intenal failure of the power supply. d) Inrush current: <20A/ms e) Earth leakage current: the earth leakage current does not exceed 0.25mA at 264V AC 66Hz input and the minimum load condition f) Efficiency: 75% min., at 220V AC input full load test 2) Output specifications: a) Output voltage: Output 1: +3.30v / 100-2000mA/+3.14V-3.46V (voltage limit)/5% tolerance Output 2: +5.00/0-1000mA/+4.75-5.25 (voltage limit)/5% tolerance Output 3: +12.0/20-500mA/+11.4-12.6 (voltage limit)/5% tolerance Output 4: +24.0/20-100mA/+21.6-26.4 (voltage limit)/7% tolerance Output 5: +30.0/0-100mA/+27.0-33.0 (voltage limit)/5% tolerance b) Output ripple: Measurement of ripple includes a 0.1uF ceramic capacitor and a 47uF electrolytic capacitor at the output of measuring oscilloscope Line ripple: measured with an oscilloscope with a bandwidth of 100MHz Switching ripple: measured with an oscilloscope with a bandwidth of 100MHz Output 1/2: 30mV at peak-peak line ripple; 200mV at peak-peak switching ripple Output 3/4/5: 60mV at peak-peak line ripple; 200mV at peak-peak switching ripple c) Turn on delay time: 1S max., at normal line full load d) Hold on time: 20mS min., at 220Vac line max load e) Over current protection: the power supply protects itself from any over current condition f) Thermal protection: the power supply protects itself down if it overheats. It resets itself with no operator invention g) Shorted output h) Hi-pot test: dielectric withstanding voltage AC input. N to all output connectors 3,000V AC for 1-minute test i) Burn-in: all power supplies will go through 4 hours of burn-in at 40 temperature chamber under the nominal input and 80% of the maximum load condition, before delivery to AMP j) PCB dimensions and weight: 165 x 70 x 45(L x W x H), 0.20kg max.